PYQSide ExamsMy practice

Semiconductor Electronics · Question 75

AIPMT 2010 (Prelims)MCQMedium📈 Topic in 12% papers+4−1
1

A common emitter amplifier has a voltage gain of 50, an input impedance of 100 and an output impedance of 200 . The power gain of the amplifier is

  1. 500
  2. 1000
  3. 1250
  4. 50

Answer

(3) 1250

Solution

Voltage gain: AV = Rout Rin

50 = 200100

= 25

Power gain = current gain × voltage gain

= AV = 25 50

= 1250

Answer: (3)

Out of syllabusAIPMT 2010 (Prelims)

Keep practising — Semiconductor Electronics

2

A p-n photodiode is fabricated from a semiconductor with a band gap of 2.5 eV. It can detect a signal of wavelength

  1. 4000 nm
  2. 6000 nm
  3. 4000 A
  4. 6000 A
AIPMT 2009
3

The symbolic representation of four logic gates are given below [figure] The logic symbols for OR, NOT and NAND gates are respectively

  1. (iv), (i), (iii)
  2. (iv), (ii), (i)
  3. (i), (iii), (iv)
  4. (iii), (iv), (ii)
AIPMT 2009
4

A transistor is operated in common-emitter configuration at VC = 2 V such that a change in the base current from 100 to 200 produces a change in the collector current from 5 mA to 10 mA. The current gain is

  1. 100
  2. 150
  3. 50
  4. 75
Out of syllabusAIPMT 2009
5

A p-n photodiode is made of a material with a band gap of 2.0 eV. The minimum frequency of the radiation that can be absorbed by the material is nearly

  1. 1 1014 Hz
  2. 20 1014 Hz
  3. 10 1014 Hz
  4. 5 1014 Hz
AIPMT 2008
6

The voltage gain of an amplifier with 9% negative feedback is 10. The voltage gain without feedback will be

  1. 1.25
  2. 100
  3. 90
  4. 10
Out of syllabusAIPMT 2008
7

Which one of the following represents forward bias diode?

  1. [figure]
  2. [figure]
  3. [figure]
  4. [figure]
AIPMT 2007
8

In the following circuit, the output Y for all possible inputs A and B is expressed by the truth table. [figure]

  1. [figure]
  2. [figure]
  3. [figure]
  4. [figure]
AIPMT 2007
9

In the energy band diagram of a material shown below, the open circles and filled circles denote holes and electrons respectively. The material is [figure]

  1. an insulator
  2. a metal
  3. an n-type semiconductor
  4. a p-type semiconductor
AIPMT 2007
10

The following figure shows a logic gate circuit with two inputs A and B and the output C. [figure] The voltage waveforms of A, B and C are as shown below. [figure] The logic circuit gate is

  1. OR gate
  2. AND gate
  3. NAND gate
  4. NOR gate
AIPMT 2006
11

Which one of the following represents forward bias diode ?

  1. [figure]
  2. [figure]
  3. [figure]
  4. [figure]
AIPMT 2006

All Semiconductor Electronics PYQs →

PDFDownload Semiconductor Electronics PYQs as PDF Free, with answer key and a QR code to every solution — print it or study offline⬇
All NEET Physics chapters