Thermodynamics (Physics) · Question 20

An ideal gas has undergone through the cyclic process as shown in the figure. Work done by the gas in the entire cycle is 10-1 J. (Take = 3.14) [figure]

Match List - I with List - II. Choose the correct answer from the options given below :

1. A-III, B-II, C-I, D-IV
2. A-II, B-IV, C-I, D-III
3. A-IV, B-II, C-III, D-I
4. A-IV, B-I, C-III, D-II

Match List - I with List - II. Q = Heat supplied W = Work done by the system U = Change in internal energy P = Pressure of the system V = Change in volume of the system Choose the correct answer from the options given below :

1. (A)-(IV), (B)-(I), (C)-(III), (D)-(II)
2. (A)-(IV), (B)-(II), (C)-(III), (D)-(I)
3. (A)-(IV), (B)-(III), (C)-(II), (D)-(I)
4. (A)-(II), (B)-(IV), (C)-(III), (D)-(I)

A gas is kept in a container having walls which are thermally non-conducting. Initially the gas has a volume of 800 cm3 and temperature 27 . The change in temperature when the gas is adiabatically compressed to 200 cm3 is: (Take = 1.5; is the ratio of specific heats at constant pressure and at constant volume)

1. 300 K
2. 600 K
3. 327 K
4. 522 K

During the melting of a slab of ice at 273 K at atmospheric pressure :

1. Internal energy of ice-water system remains unchanged.
2. Positive work is done by the ice-water system on the atmosphere.
3. Positive work is done on the ice-water system by the atmosphere.
4. Internal energy of the ice-water system decreases.

[figure] A piston of mass M is hung from a massless spring whose restoring force law goes as F = -kx3, where k is the spring constant of appropriate dimension. The piston separates the vertical chamber into two parts, where the bottom part is filled with 'n' moles of an ideal gas. An external work is done on the gas isothermally (at a constant temperature T) with the help of a heating filament (with negligible volume) mounted in lower part of the chamber, so that the piston goes up from a height L0 to L1, the total energy delivered by the filament is: (Assume spring to be in its natural length before heating)

1. nRT ( L1L0 ) + Mg(L1 - L0) + 3k4 (L14 - L04 )
2. nRT ( L1L0 ) + Mg(L1 - L0) + k4 (L14 - L04 )
3. nRT ( L12L02 ) + Mg2(L1 - L0) + k4 (L14 - L04 )
4. 3nRT ( L1L0 ) + 2Mg(L1 - L0) + k3 (L13 - L03 )

An ideal gas exists in a state with pressure P0, volume V0. It is isothermally expanded to 4 times of its initial volume (V0), then isobarically compressed to its original volume. Finally the system is heated isochorically to bring it to its initial state. The amount of heat exchanged in this process is

1. P0V0( 2 - 0.75)
2. P0V0(2 2 - 0.75)
3. P0V0(2 2 - 0.25)
4. P0V0( 2 - 0.25)

In an adiabatic process, which of the following statements is true?

1. The internal energy of the gas decreases as the temperature increases
2. The molar heat capacity is zero
3. Work done by the gas equals the increase in internal energy
4. The molar heat capacity is infinite

Identify the characteristics of an adiabatic process in a monoatomic gas. Choose the correct answer from the options given below :

1. (B), (D) only
2. (B), (E) only
3. (A), (C), (E) only
4. (A), (C), (D) only

The work done in an adiabatic change in an ideal gas depends upon only :

1. change in its pressure
2. change in its temperature
3. change in its specific heat
4. change in its volume