PYQSidePowered by
ExamsMy practice
A potential divider circuit is shown in figure. The output voltage V0 is : [figure]
(3) 0.5 V
All resistors are in series: R=3300+7 100=4000
I= 44000=10-3 A
V0 is taken across the last five 100 resistors (500 ):
V0=10-3 500=0.5 V
Answer: (3)
An electric toaster has resistance of 60 at room temperature (27 ). The toaster is connected to a 220 V supply. If the current flowing through it reaches 2.75 A, the temperature attained by toaster is around : ( if =2 10-4/ )
Two cells are connected in opposition as shown. Cell E1 is of 8 V emf and 2 internal resistance; the cell E2 is of 2 V emf and 4 internal resistance. The terminal potential difference of cell E2 is V. [figure]
When a potential difference V is applied across a wire of resistance R, it dissipates energy at a rate W. If the wire is cut into two halves and these halves are connected mutually parallel across the same supply, the energy dissipation rate will become:
Two resistances of 100 and 200 are connected in series with a battery of 4 V and negligible internal resistance. A voltmeter is used to measure voltage across 100 resistance, which gives reading as 1 V. The resistance of voltmeter must be .
The electric current through a wire varies with time as I=I0+ t, where I0=20 A and =3 A/s. The amount of electric charge crossed through a section of the wire in 20 s is :
In the given circuit, the current in resistance R3 is : [figure]
In the given circuit, the current flowing through the resistance 20 is 0.3 A, while the ammeter reads 0.9 A. The value of R1 is . [figure]
In the given figure, the charge stored in 6 capacitor, when points A and B are joined by a connecting wire is . [figure]
A wire of length 10 cm and radius 7 10-4 m is connected across the right gap of a meter bridge. When a resistance of 4.5 is connected on the left gap by using a resistance box, the balance length is found to be at 60 cm from the left end. If the resistivity of the wire is R 10-7 , then value of R is :
A wire of resistance R and length L is cut into 5 equal parts. If these parts are joined parallely, then resultant resistance will be :