Current Electricity · Question 53

Across a metallic conductor of non-uniform cross section a constant potential difference is applied. The quantity which remains constant along the conductor is

1. drift velocity
2. electric field
3. current density
4. current

A potentiometer wire has length 4 m and resistance 8 . The resistance that must be connected in series with the wire and an accumulator of e.m.f. 2 V, so as to get a potential gradient 1 mV per cm on the wire is

1. 44
2. 48
3. 32
4. 40

The resistances in the two arms of the meter bridge are 5 and R respectively. When the resistance R is shunted with an equal resistance, the new balance point is at 1.6 l1. The resistance R is [figure]

1. 10
2. 15
3. 20
4. 25

Two cities are 150 km apart. Electric power is sent from one city to another city through copper wires. The fall of potential per km is 8 volt and the average resistance per km is 0.5 . The power loss in the wire is

1. 19.2 W
2. 19.2 kW
3. 19.2 J
4. 12.2 kW

A potentiometer circuit has been set up for finding the internal resistance of a given cell. The main battery, used across the potentiometer wire, has an emf of 2.0 V and a negligible internal resistance. The potentiometer wire itself is 4 m long. When the resistance R, connected across the given cell, has values of (i) infinity, (ii) 9.5 , the balancing lengths on the potentiometer wire are found to be 3 m and 2.85 m, respectively. The value of internal resistance of the cell is

1. 0.25
2. 0.95
3. 0.5
4. 0.75

The resistances of the four arms P, Q, R and S in a Wheatstone's bridge are 10 ohm, 30 ohm, 30 ohm and 90 ohm, respectively. The e.m.f. and internal resistance of the cell are 7 volt and 5 ohm respectively. If the galvanometer resistance is 50 ohm, the current drawn from the cell will be

1. 0.1 A
2. 2.0 A
3. 1.0 A
4. 0.2 A

The internal resistance of a 2.1 V cell which gives a current of 0.2 A through a resistance of 10 is

1. 0.8
2. 1.0
3. 0.2
4. 0.5

A wire of resistance 4 is stretched to twice its original length. The resistance of stretched wire would be

1. 8
2. 16
3. 2
4. 4

Two rods are joined end to end, as shown. Both have a cross-sectional area of 0.01 cm2. Each is 1 meter long. One rod is of copper with a resistivity of 1.7 10-6 ohm-centimeter, the other is of iron with a resistivity of 10-5 ohm-centimeter. [figure] How much voltage is required to produce a current of 1 ampere in the rods?

1. 0.00145 V
2. 0.0145 V
3. 1.7 10-6 V
4. 0.117 V

A 12 cm wire is given a shape of a right angled triangle ABC having sides 3 cm, 4 cm and 5 cm as shown in the figure. The resistance between two ends (AB, BC, CA) of the respective sides are measured one by one. Their ratio is [figure]

1. 9 : 16 : 25
2. 27 : 32 : 35
3. 21 : 24 : 25
4. 3 : 4 : 5