PYQSide ExamsMy practice

Current Electricity · Question 55

AIPMT 2015 (Cancelled)MCQEasy📈 Topic in 0% papers+4−1
1

A potentiometer wire has length 4 m and resistance 8 . The resistance that must be connected in series with the wire and an accumulator of e.m.f. 2 V, so as to get a potential gradient 1 mV per cm on the wire is

  1. 44
  2. 48
  3. 32
  4. 40

Answer

(3) 32

Solution

Potential gradient = 1 mV/cm = 0.1 V/m

P.d. across the wire = 0.1 4 = 0.4 V

Current: I = 0.48 = 0.05 A

I = 28 + R 8 + R = 20.05 = 40

R = 32

Answer: (3)

AIPMT 2015 (Cancelled)

Keep practising — Current Electricity

2

The resistances in the two arms of the meter bridge are 5 and R respectively. When the resistance R is shunted with an equal resistance, the new balance point is at 1.6 l1. The resistance R is [figure]

  1. 10
  2. 15
  3. 20
  4. 25
AIPMT 2014
3

Two cities are 150 km apart. Electric power is sent from one city to another city through copper wires. The fall of potential per km is 8 volt and the average resistance per km is 0.5 . The power loss in the wire is

  1. 19.2 W
  2. 19.2 kW
  3. 19.2 J
  4. 12.2 kW
AIPMT 2014
4

A potentiometer circuit has been set up for finding the internal resistance of a given cell. The main battery, used across the potentiometer wire, has an emf of 2.0 V and a negligible internal resistance. The potentiometer wire itself is 4 m long. When the resistance R, connected across the given cell, has values of (i) infinity, (ii) 9.5 , the balancing lengths on the potentiometer wire are found to be 3 m and 2.85 m, respectively. The value of internal resistance of the cell is

  1. 0.25
  2. 0.95
  3. 0.5
  4. 0.75
AIPMT 2014
5

The resistances of the four arms P, Q, R and S in a Wheatstone's bridge are 10 ohm, 30 ohm, 30 ohm and 90 ohm, respectively. The e.m.f. and internal resistance of the cell are 7 volt and 5 ohm respectively. If the galvanometer resistance is 50 ohm, the current drawn from the cell will be

  1. 0.1 A
  2. 2.0 A
  3. 1.0 A
  4. 0.2 A
NEET 2013
6

The internal resistance of a 2.1 V cell which gives a current of 0.2 A through a resistance of 10 is

  1. 0.8
  2. 1.0
  3. 0.2
  4. 0.5
NEET 2013
7

A wire of resistance 4 is stretched to twice its original length. The resistance of stretched wire would be

  1. 8
  2. 16
  3. 2
  4. 4
NEET 2013
8

Two rods are joined end to end, as shown. Both have a cross-sectional area of 0.01 cm2. Each is 1 meter long. One rod is of copper with a resistivity of 1.7 10-6 ohm-centimeter, the other is of iron with a resistivity of 10-5 ohm-centimeter. [figure] How much voltage is required to produce a current of 1 ampere in the rods?

  1. 0.00145 V
  2. 0.0145 V
  3. 1.7 10-6 V
  4. 0.117 V
NEET 2013 (Karnataka)
9

A 12 cm wire is given a shape of a right angled triangle ABC having sides 3 cm, 4 cm and 5 cm as shown in the figure. The resistance between two ends (AB, BC, CA) of the respective sides are measured one by one. Their ratio is [figure]

  1. 9 : 16 : 25
  2. 27 : 32 : 35
  3. 21 : 24 : 25
  4. 3 : 4 : 5
NEET 2013 (Karnataka)
10

Ten identical cells connected in series are needed to heat a wire of length one meter and radius 'r' by 10 in time 't'. How many cells will be required to heat the wire of length two meter of the same radius by the same temperature in time 't' ?

  1. 20
  2. 30
  3. 40
  4. 10
NEET 2013 (Karnataka)
11

A cell having an emf and internal resistance r is connected across a variable external resistance R. As the resistance R is increased, the plot of potential difference V across R is given by

  1. [figure]
  2. [figure]
  3. [figure]
  4. [figure]
AIPMT 2012 (Mains)

All Current Electricity PYQs →

PDFDownload Current Electricity PYQs as PDF Free, with answer key and a QR code to every solution — print it or study offline⬇
All NEET Physics chapters